Prohibited Use - Tractel stopfor K Instructions D'emploi

• M23: steel connector with triple safety locking.
Lanyard type end:
• Removable lanyards of 0.3 m long:
– LS03 M10 M41: strap lanyard 0.3 m with M10 and
M41 connector
– LS03 M10 M42: strap lanyard 0.3 m with M10 and
M42 connector
6. Device contents
stopfor™ range composition table
stopfor™ K MXX
stopfor™ K
stopfor™ K LS0,3 MXX MXX
stopfor™ KS MXX
stopfor™ KS
stopfor™ KS LS0,3 MXX MXX
stopfor™ KSP MXX
stopfor™ KSP
stopfor™ KSP LS0,3 MXX MXX
L: Termination of the device
b: Device designation
RLXD: Belay Support Reference
6. Clearance
6.1. Vertical use (Fig. 3, page 3)
Before each use, you must check that the
clearance under the device (L) is equal to at
least twice the length of the lanyard used (L1),
plus one metre for braking (L2), plus one metre
for safety (L3), plus the elastic elongation (L4) of
the rope used.
6.2. Horizontal use (Fig. 4, page 3)
For stopfor™ K, KS and KSP before each use, iyou
must check that the draft (L) under the device is greater
than the sum of twice the length of the lanyard used
(L1) plus 4.50 metres for braking (L2), plus one safety
Apparatus
b
DANGER
– LS03 M10 M10T: strap lanyard 0.3 m with M10
and M10T connector
5. The connectors (Fig. 1, page 2, J)
The breaking strength of the connectors supplied with
the lanyard is greater than 22 kN.
L
MXX
LS0,3 MXX MXX
MXX
LS0,3 MXX MXX
MXX
LS0,3 MXX MXX
metre (L3), plus the elastic elongation of the rope used
(L4), plus the height of the back of the harness of the
person in relation to the ground (L5), plus the maximum
deflection of the anchor point defined in the operating
instructions of the anchor point.

7. Prohibited use

It is strictly forbidden:
• to install or use the stopfor™ fall-arrester without first
having been authorised, trained and recognised to be
qualified in the use of the device, or otherwise, without
the supervision of an authorised technician, trained
and recognised to be qualified in use of the device.
• to use the stopfor™ fall-arrester if any of the
markings are not legible.
• to install or use the stopfor™ fall-arrester without first
having carried out the preliminary checks.
• to use a stopfor™ fall-arrester which has not been
covered by a periodic inspection over the past 12
months by a technician having authorised re-use in
writing.
Type of
flexible Horizontal
belay use
support
OK
RLXD 11
OK
OK
RLXD 11
OK
OK
RLXD 11
OK
GB
7