Copilot; Controlling The Motor With Copilot; Copilot General Operation - MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire

Masquer les pouces Voir aussi pour RIPTIDE POWERDRIVE:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROLLING THE MOTOR WITH COPILOT

Review the complete CoPilot section of this manual to become
familiar with this feature. For more information on CoPilot or for
additional product support, please visit minnkotamotors.com.
Steer Left
Prop ON/OFF
This button is located in the middle of the remote. It turns the propeller on or off. Press the button once to turn the propeller ON; press
button a second time to turn it OFF. The button does not need to be held down.
Steer Left & Steer Right
These buttons are located to the right and left of the Prop ON/OFF button and have an arrow symbol. They cause the motor to turn in
the desired direction as long as the button is held down. If the Steer Right or Steer Left button is held for more than seven seconds, the
steering will automatically stop until the button is pressed again.
Increase Speed & Decrease Speed
The Increase Speed and Decrease Speed buttons are located on the top of the remote and are identified with a positive and negative
symbol. Pressing and releasing these buttons causes the speed to increase or decrease by increments of 1. The speed is adjustable
from level 0-10. At level 0, the prop will not turn.
In audio mode 2, an audible beep is heard for each increment when changing speed. Attempting to go higher than speed 10 or lower
than speed 0 will result in the speed
If the receiver senses no foot pedal (if applicable) or remote operation for 1 hour, the remote speed setting is automatically set to zero.
This helps prevent unintentional activation of the propeller if the prop on/off remote button is inadvertently pressed.

COPILOT GENERAL OPERATION

Operating with the Remote and Foot Pedal
• When the Momentary/Constant Switch on the Foot Pedal is in the CON position or when the Momentary Button is held, the receiver
WILL NOT RESPOND to any remote commands. When remote commands are received, the receiver will emit an audible chirp. This will
indicate that the remote is functioning properly, but the Foot Pedal is active and is overriding the remote.
• When the Momentary/Constant Switch is in the MOM position, the operator may begin using the remote at any time.
©2021 Johnson Outdoors Marine Electronics, Inc.

COPILOT

Decrease Speed
not
changing and no beep will be heard. See the Audio Mode section for more information.
NOTICE:
Your motor may come factory installed
with CoPilot.
Increase Speed
Prop ON/OFF
Steer Right
(Foot Pedal only available on select models.)
minnkotamotors.com | 27

Publicité

Chapitres

Table des Matières
loading

Table des Matières