MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire page 12

INSTALLING THE RIPTIDE POWERDRIVE
8
ITEM(S) NEEDED
#2 x 6
l. Place a Flat Washer (Item #2) and then a Nylock Nut
(Item #3) at the end of each screw as shown and
secure. Make sure all hardware is secure.
NOTICE:
To prevent seizing of the stainless steel
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
9
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
9m
12 | minnkotamotors.com
#3 x 6
Right Sideplate Right Sideplate
1/4-20 x 3 1/2" Screw
9n
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
Rubber Washer Rubber Washer
Boat Deck Boat Deck
Flat Washer
Nylock Nut
©2021 Johnson Outdoors Marine Electronics, Inc.