Adjusting The Lower Unit For A Secure Stow - MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire

ADJUSTING THE LOWER UNIT FOR A SECURE STOW

Adjusting the Lower Unit for a Secure Stow
When the Motor is stowed, the Lower Unit should rest on the Mount Ramp, a part of the Motor Mount. It is recommended to secure the
motor using the following instructions to avoid damage to the motor and shaft from vibrations during transport.
1
a. Before transporting the boat over water or land, stow
the motor to determine where the Lower Unit rests on
the Mount Ramp.
NOTICE:
The correct positioning of the Lower Unit will
place it directly on the Mount Ramps.
b. If the Lower Unit does not sit on the Mount Ramps,
refer to the Adjusting the Latch Collar section of this
manual. Making adjustments to the Latch Collar will
help the Lower Unit stay on the Mount Ramps as it is
captured by the Deploy Assist Lever.
CAUTION
The Lower Unit should be placed on the Mount Ramps
every time the motor is transported. If the Lower Unit is
improperly placed, either above or below the Motor Rest
Area, damage to the Lower Unit or Shaft will occur and
the Shaft will be incorrectly captured. Not following the
recommended placement for the Lower Unit will cause
damage to the product and void your product warranty.
24 | minnkotamotors.com
Mount
Ramps
Deploy Assist Lever
NOTICE:
Slide the Depth Collar down and secure
it against the top of the Steering Housing when
stowed to secure the motor in place and prevent
accidental deployment.
Lower Unit
Latch Collar
Depth
Collar
©2021 Johnson Outdoors Marine Electronics, Inc.
Shaft