MINN KOTA RIPTIDE POWERDRIVE Manuel Du Propriétaire page 13

10
o. Replace the four sideplate screws using a #3 or #2
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
11
ITEM(S) NEEDED
#17 x 5
p. Take the Foot Pedal (Item #10) and turn it over.
Put a Foot Pedal Pad (Item #17) in each of the
pad locations.
NOTICE:
The pads are recommended when using
the Foot Pedal on non-carpeted surfaces.
©2021 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RIPTIDE POWERDRIVE
#10 x 1
Sideplate Screw Sideplate Screw
Foot Pedal Foot Pedal
Bottom Bottom
Foot Pedal Foot Pedal
Pad Pad
Placement Placement
minnkotamotors.com | 13