Multiplex MULTImate V 1.42 Instructions page 37

7. M 6: MULTI
ENU
A fully charged flight battery is required for programming MULTIcont BL-XX speed controllers (BL-17/II, BL-27/II, BL-
37/II and BL-54).
• Locate the UNI lead attached to the MULTIcont BL-XX speed controller, and connect it to the PC and Data port on
one end of the MULTImate.
Note: The flight battery must be connected and disconnected at the right moment; please refer to the flow chart below.
Caution: Always proceed exactly as described in the instructions, as the MULTImate processes servo signals
when programming MULTIcont BL-XX speed controllers. If you neglect this, the motor could burst into life
unexpectedly (injury hazard)! For safety's sake you can disconnect one of the three motor wires before starting
the programming procedure.
Action & Display
6 MULTIcont BL
6-1 Battery mode
LiPo
6-2 Brake
off
6-3 Reverse
off
6-4 Send data
Power off!
6-4 Send data
Power on!
6-4 Send data
please wait...
automatic
6-4 Send data
OK!
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
BL
CONT
6 Go back
...to main menu
, or
Explanation
Main menu display „6 MULTIcont BL"
Setting the battery type
• Battery type "LiPo" or "NiXX" is selcted using and
or , confirm the setting with
Setting the brake function
• Brake "on" / "off" or "ein" / "aus" can be selected using
and or , confirm the setting with
Setting the direction of motor rotation
• Motor reverse "on" / "off" or "ein" / "aus" can be
selected using and
with
To prepare for sending the selected data:
switch voltage off (disconnect battery)!
Important! Always set all three possible parameters
- battery mode, brake and motor reverse - as required,
as the menu always starts with default values (the
current settings of the speed controller cannot be read
out)!
Connect the flight battery to the speed controller
(voltage on)
The transfer process
The transfer process is automatic; please wait
When the data transfer is concluded, the screen
automatically switches to: "5-4 Send data --> OK!" or
"5-4 Daten senden --> OK!"
Caution: disconnect battery when finished (voltage off)
or , confirm the setting
Seite 14/22