Multiplex MULTImate V 1.42 Instructions page 32

4. M 3: RX-S
ENU YNTH
The MULTImate can be used to program any MULTIPLEX RX-SYNTH M-PCM receiver.
Note: the voltage of the power supply must be at least 4.8 V!
• Connect the receiver (socket "B/D") to the PC and Data port on one end of the MULTImate using the data lead sup-
plied in the set.
Action & Display
3 RX-Synth M-PCM
3-1 RF channel
063 – 35,030 MHz
3-2 Failsafe
3-3 Hold length
0.9 sec
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
M-PCM
3 Go back
...to main menu
3-2 Go back
...to RX M-PCM
3-2 Servo 1
L < FS off >
(...)
(...)
3-2 Servo 4
L << 1453 µs
(...)
(...)
3-2 Servo 12
L << 1500µs >>
3-2 FS length
16.0 sec
Explanation
Main menu display "3 RX-Synth M-PCM"
Selecting the RF channel
•
Change the channel using
confirm the set channel with
Note: After receiver RESET the screen displays
"Chan. Search" or "HF-Kanal Kanalsuche"
Selecting the Fail-Safe setting for servos 1, ..., 12
•
Select servo 1, ..., 12 using
•
Change the fail-safe setting for the selected servo:
• Fail-safe for each servo "on" / "off"
or "ein" / "aus":
• Change fail-safe setting:
and or , confirm with
Note: After receiver reset for all servos:
Fail-safe "off" or "aus"
Selecting the Fail-Safe period (max. fail-safe period
after hold period has elapsed)
•
Can be selected from 0.0 sec to 20.0 sec.
•
Change value using and
selected value with
Selecting the Hold period; applies to all servos
•
Can be selected from 0.1 sec to 2.8 sec.
•
Change value using and
set value with
and or ,
or
or , confirm the
or , confirm the
Seite 9/22