Multiplex MULTImate V 1.42 Instructions page 31

2-6 Options
2-7 RX type
RX7 35A V1.21
2-8 RX reset
L
2-9 Send data
L
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
2-6 Go back
...to RX IPD
2-6 Pulse
MPX-MPX
2-6 IPD
on
2-6 Shift
not available
Selecting the servo signal output format for twelve-
channel mode
•
"MPX-MPX" = MPX 12-channel mode (PPM12) with
MPX servo signal output format
•
"MPX-UNI" = MPX 12-channel mode (PPM12) with
UNI servo signal output format
•
"Graupner" = Graupner 12-channel mode (PPM24)
•
Change format using , then
transmission format with
Selecting the IPD filter
Selecting the IPD filter after switching the receiver on:
•
"on" / "off" or "ein" / "aus", to change, then
or , confirm with
Note: to change the receiver state (IPD "on" / "off" or
"ein" / "aus") while in use: hold the SET button pressed
in for > two seconds
Shift switching
(72MHz receivers only)
•
Switch shift positive / negative with ,
then or , confirm with
Display of connected receiver type
•
Description (RX7)
•
Frequency band (35 MHz A-band)
•
Software version (V1.21)
If you wish to reset the receiver to the factory default
settings (Reset):
Caution:
The previously set values and / or data must be sent
to the receiver via this menu point, otherwise they
will not take effect.
The only exception from this is the menu point:
"2-8 RX reset"
• To send the selected data:
or , confirm the set
Seite 8/22