Multiplex MULTImate V 1.42 Instructions page 44

11-2 Clear opt.
L
11-3 Settings
MULTIPLEX Modellsport GmbH & Co.KG • Westliche Gewerbestraße 1 • D-75015 Bretten (Gölshausen) • www.multiplex-rc.de
Operating Instructions - MULTImate – V1.42
11-3 Go back
to Sensors
T1: Address
L 4
T1: Alarm low
L off
T1: Alarm high
L off
T1: Option
Max value
T1: Option addr.
L off
T2: Address
L off
T2: Alarm low
L off
T2: Alarm high
L off
Erasing the set option values
resets the option values for the connected sensor
which were previously activated and saved during a
flight.
(maximum value, minimum value and average value)
Displaying and configuring the possible sensor
values for the connected sensor
This example shows the temperature sensor with its
two measurement channels T1 and T2.
Setting the screen address on the transmitter
• Available range: 0 ... 15
• Activate the menu point with , then
the value, and confirm the set value with
• Disable / activate the address with
Setting the bottom alarm threshold
• Available range: -25 ... +700° C
•
activates / disables the menu point. Use ,
to set the value for the bottom alarm threshold, then
confirm the selected value with
Setting the top alarm threshold
• Method as for bottom alarm threshold
Selecting the option value
• Possible settings: maximum, minimum or average
value
•
activates the menu point, use
then confirm the selection with
Setting the screen address for the option value
• Available range: 0 ... 15
• Disable / activate the address with
• Set the menu point with , then
value, confirm the set value with
☞ Carry out the same procedure for channel 2 of
the temperature sensor, working through the
address, alarm and option values. The remaining
settings for temperature channel 2 are entered
using the same procedure as those for channel 1.
! !
! !
Always conclude your data entry with the menu
point "11-3 Data send", otherwise the altered
settings will not be transferred to the sensor.
or to set
or
or to select,
or to adjust the
Seite 21/22