Adjustment Side Clamping; Gripper Length Adjustment Of Side Clamping; Gripper Depth Adjustment Of Side Clamping - probst HVZ-UNI-II Instructions D'emploi

Adjustments
5.8

Adjustment side clamping

5.8.1

Gripper length adjustment of side clamping

Fig. 7
5.8.2

Gripper depth adjustment of side clamping

Fig. 8
●
paver thickness 6 cm
depth-adjustment in position 1
●
Check the measurement of the depth of the laying cluster.
●
Included in the delivery there are two C-profiles (standard
length 850 mm)
●
Shorten them to about 50 mm less than the depth of the laying
cluster by cutting them or ordering them with the supplier.
●
If the C-profiles have to be shortened, shorten them by the
same amount on both sides in order to have the holes in the C-
profiles still in the centre of the profiles.
●
Fix the side gripper holder as shown. Do not tighten the screws
completely.
●
The position of the C-profiles on the side gripper holder has to
be done exactly, only tighten the screws completely
afterwards.
Fig. 9
●
paver thickness 8 cm
depth-adjustment in position 2
Fig. 10
●
paver thickness 10 cm
depth-adjustment in position 3
25 / 41