Gripping Depth - Machine Side - probst HVZ-UNI-II Instructions D'emploi

Adjustments
Pull the spring bolt upwards, rotate around 180° and lock in
position (in nick).
Adjust gripping depth and rotate the spring bolt again
around 180°.
Fig. 7
5.2.2

Gripping depth - Machine Side

The adjustment of the gripping depth of the lamella grips on
the machine side is occurred by a central thread bolt.
Adjust the gripping depth (machine side) so, that the steel-
lamellas are gripping in the
Example: with stone layer breadth of 80 mm  40 mm
Swing the crank upwards.
With the crank adjust the position of the steel-lamellas so
they are gripping in the
Swing the crank downwards to save it from autonomous
rotating.
½
of the stone layer (see fig. 8).
½
of the stone layer.
Fig. 9
Adjust the gripping depth distance approx. on 100 – 150 mm
from the middle of the gripping depth to the outside edge
of the stone layer (see stickers at the device).
100 – 150 mm
With extremely large stone layers it recommends to adjust
the gripping depth a little lower, so that the steel-lamellas
grip in the lowest range of the stone layer (see Fig. A).
Otherwise it exist the danger that the stone layer breaks
out.
½
Fig A
18 / 41
Fig. 8