Installing Your Hob In All Simplicity; Fitting Recommendations - Brandt TE214WS1 Guide D'utilisation

99625732_ML_B.qxd 16/12/02

Installing your hob in all simplicity

F
itting recommendations
Model
Standard cutout
Outside
dimensions above
the work surface
Outside
dimensions below
the work surface.
This appliance should be installed by
a qualified technician / installer.
Prior to installation, ensure that the
local distribution conditions (nature
of the gas and gas pressure) and the
adjustment conditions of the
appliance are compatible.
These hobs are designed to be used by
private individuals in their homes.
The adjustment conditions are stated on
a label in the wallet and also on the
packaging.
This appliance must be installed and
connected in compliance with the
regulations in force, and used only in a
well-ventilated
instructions before installing and using
this appliance.
Carefully look after these instructions, with the information label affixed to
the final page, and keep them near your appliance.
11:04 Page 29
Width
56 cm
60 cm
55 cm
area. Consult the
Depth
Depending on the unit
49 cm
53 cm
47,5 cm
Since this appliance is not connected to a
combustion products evacuation device.
Particular attention should be given to the
relevant requirements
ventilation.
On this subject, combustion can take
place only if oxygen from the air is
present, so this air must be constantly
renewed and the combustion products
must be evacuated (a minimum air input
of 2 m3/hour per kw of gas energy is
required).
These hobs have type X protection (in
accordance with standard EN 60.335.2.6)
against overheating of cupboards and
Class 3 for installation itself (in
accordance with standard EN 30.1.1).
Height
5,8 cm
3,4 cm
regarding
29