Brandt TE214WS1 Guide D'utilisation page 36

99625732_ML_B.qxd 16/12/02
C
hanging the type of gas supply (cont'd)
When carrying out this operation, you
should successively:
Adapt the gas connection
Change the injectors
Adjust the retarder on the taps
A
DAPT THE HOB CONNECTION
gas adjustment. Refer to the paragraph
"Gas connections".
C
HANGE THE INJECTORS
way:
• Remove the supports, and all the bur-
ner caps and heads.
• Using the spanner supplied, unscrew
the injectors at the bottom of each dish
and remove them (fig 1).
- Replace these with the injectors
supplied in the wallet, in accordan-
ce with the gas rating table at the
end of the chapter; to do this:
Screw in the injectors by hand un-
til they are tight.
Put the spanner well onto the in-
jector.
With a pencil draw a line on the
hearth plate as indicated (fig. 2).
Turn the spanner clockwise until
the line appears on the other side
(fig. 3). Warning! Do not go
beyond this limit as you are
liable to cause damage.
Put the burner heads, covers and
pan supports back in position.
36
11:05 Page 36
Installing your hob in all simplicity
to the new
in the following
Upper side of the hob
Fig. 2
Grill
Cover
Head
Dish
Injector
Fig. 1
Spanner
Line
Fig. 3