Brandt TE214WS1 Guide D'utilisation page 30

99625732_ML_B.qxd 16/12/02 11:04 Page 30
Installing your hob in all simplicity
F
itting recommendations (cont'd)
The hob must be built into the work-
top of a support cupboard. This work-
top must be at least 3 cm thick and
heat-resistant or else coated with a
heat resistant material.
A s i d e - c l e a r a n c e o f a t l e a s t 3 0 c m
should be left to the right and left of
the hob. A tall cupboard or partition
too close to the hob would hinder free
m o v e m e n t o f k i t c h e n u t e n s i l s .
If a horizontal partition is put under
the hob, it must be placed between 10
a n d 1 5 c m f r o m t h e b o t t o m o f t h e
work top. In any case, do not keep
any sprays or pressurized containers
in the compartment which could be
just under the hob.
To ensure the seal between the hob
and the worktop, affix the joint provi-
Fixing lugs F
RONT
ded in the folder before installing the
hob:
1- Remove the pan support grates, the
burner caps and heads after checking
their position.
2- Turn the hob over and place it gently
over the opening in the worktop paying
attention not to damage the control
knobs and lighters.
3- Stick the foam seal around the out-
side of the hob.
4- Put the hob back the right way up
and place the burners, caps and pan
grates back in position.
Fixing lugs B
ACK
30