How To Look After Your Hob - Brandt TE214WS1 Guide D'utilisation

99625732_ML_B.qxd 16/12/02

How to look after your hob?

Keeping your hob in good condition is easy if you clean it before it is completely
cold. Even so, never clean it when it is in use. Put all the electric and gas control
knobs at zero.
Looking after
sparkers and
injectors
Looking after
the grills and
burners
Looking after
the electric
hotplate
Looking after
enamel or
stainless steel.
- It is better to clean the elements of your hob by hand, do not put any parts
in the dishwasher.
- Never use scouring pads for cleaning your hob.
11:05 Page 43
HOW TO PROCEED
- If ever the sparkers
get dirty, clean them
with a stiff non-
metallic brush.
Nut
- The gas injectors are
in the centre of each
burner in the form of
a "pot". Make sure not
thermocouple
to block them up
partially when
cleaning the hob, as this will considerably
reduce the performance of your gas-rings.
- Use a non-abrasive cream for removing any
persistent stains. Then rinse with clean
water. Dry each burner element carefully
before re-lighting your hob.
- The electric hotplate is protected by a black
surface coating. Therefore, avoid using any
abrasive products. After use, wipe it clean
with an oily cloth.
- If ever a electric hotplate starts to rust,
remove the rust with (with emery paper or
similar) and re-coat the electric hotplate with
a high-temperature renovating product to be
found at your local distributor.
- Use polishing cream for cleaning the enamel
on the hob. Polish with a dry clean cloth.
- Never allow any acid liquids such as lemon
juice, vinegar, etc. to remain in contact with the
enamel.
- Use a sponge and soapy water or a standard
stainless steel cleaner for cleaning the stainless
steel parts on your hob.
ACCESSORIES TO
BE USED
Injector
Sparker
- Small hard-bristled
brush.
- Safety pin
- Non-abrasive cream.
- Household sponge.
- Renovating product
available in the shops.
- Soft polishing
cream.
- Standard stainless
steel cleaning
product
43