Brandt TE214WS1 Guide D'utilisation page 34

99625732_ML_B.qxd 16/12/02
G
as connections (Cont'd)
Possible connections
B
OTTLED OR TANKED GAS
).
PANE
For the user's safety, we advise the
connection to be made with a rigid pi-
pe if this is possible.
For an existing installation, where
it is not possible to fit a reinforced,
braided, flexible gas hose, the connec-
tion can be made with a flexible gas
hose (maximum length 2 metres), wi-
th two jubilee clips: one on the
connector (fig. B), and the other on
the pressure regulator, and a gas
proof washer should be fitted between
the connector and the elbow seal on
the hob.
You will find the sealing washer and
the adaptor in the wallet delivered wi-
th the unit.
Temperatures above 30°C would cause overheating of the gas hose. To
avoid this, check that there are no heat-producing devices nearby.
Screw on the connector with a torque not exceeding 2.5 m/daN (m/kgF).
34
11:05 Page 34
Installing your hob in all simplicity
( / -
BUTANE PRO
BUTANE/PROPANE
Pressure regulator compulsory
butanenepropane
fig. 2
Elbow joint
Gas proof washer
(supplied)
Connector (supplied)
Jubilee clip
(not supplied)
fig.B
Flexible hose
connection
propane
propane