Gas Connections - Brandt TE214WS1 Guide D'utilisation

99625732_ML_B.qxd 16/12/02
G
as connections
Preliminary remarks
If the hob is to be installed above an oven
or if other
appliances risk heating and damaging the
gas hose then it is essential that a rigid pi-
pe be installed
If a flexible hose is used (in the case of bu-
tane gas) then it must not be installed in a
place where it may be in contact with a
moving part of the kitchen unit or a place
likely to get cluttered.
Possible connections
T (
OWN GAS NATURAL GAS
Choose the connection exclusively accor-
ding to:
- connection with a rigid pipe (gas
standard G1/2).
The connection should be made at the end of
the elbow seal on the appliance, using the co-
nical connection with the sealing washer
provided in the folder.
Note : Screw on the connector with a
torque not exceeding 2.5 m/daN (m/kgF).
Whatever means of connections is chosen, make sure that it is gas sound after installa-
tion by using soapy-water.
11:05 Page 33
Installing your hob in all simplicity
nearby heating
instead.
)
.
NATURAL GAS
Meter
fig.1
Gas proof washer
(supplied)
Conical connection
(supplied)
33