Mounting And Dismounting A Tray - Sartorius Stedim Biotech CERTOMAT Tplus Mode D'emploi

2.4.3 Mounting and Dismounting a Tray

3 a
3 c
Fig. 10: Mounting of the tray on the shaking table
(tray shown without mounting systems and
containers)
12
1 b
1 a
2 b
3 b
1 c
2 a
1 d
4
2 c
3 d
1. Place the tray onto the shaking table. Push it with the
indents (1a/1b) against the rear knurled screws (1c/1d)
and the clamp (2a) of the shaking table.
Please mind the weight of the tray if you have already
loaded it with shaking containers.
2. Push down (2b) the front edge of the tray so that it
properly fits into the front clamp (2c).
3. The borings (3a/3b) will precisely fit onto the locating
pins of the tray support (3c/3d) and locate the tray.
Please take care that the locating pins (3c/3d) are placed
evenly in the tray. Only then the tray is situated
correctly on the shaking table.
If necessary, you can adjust the locating pins as follows:
1. Release the screws of the locating pins (3c/3d) with
the hexagon socket screw key.
2. If necessary, move the tray slightly. The locating pins
(3c/3d) position themselves in the centre of the
borings (3a/3b) of the tray.
3. Tighten the screws of the locating pins (3c/3d)
carefully again after adjusting the tolerance.
4. In order to improve the safe position of the tray –
especially at high loads in connection with high speed
– the provided flat headed screws M5 x 8 must be
screwed in the prepared borings.