Recommendations For Installation; Location Of Weighing Modules - Minebea Intec Novego Manuel D'installation

Hygienic Weighing Module Novego®
3

Recommendations for installation

3.1

Location of weighing modules

Minebea Intec
-
The underframe of the vessels must be strong enough to support the speciied loads,
horizontal (water level!) and lat.
Note:
A pendulum base with tilt correction compensates for any inclination of ≤3°.
- Preferably, vessels should be installed on 3 weighing modules.
- The weighing modules should be arranged evenly over the entire vessel.
- Parasitic and/or horizontal forces and torques exceeding the permissible limits are
disturbances which can generate measuring failures and, in the worst case, may
damage the load cell.
-
The pendulum bases absorb the occurring transverse forces within the limit values.
-
No constrainer is necessary because of the 360° stopper integrated in the pendulum
base.
-
If 3 weighing modules are used, the weighing system can absorb 3 times the
maximum capacity of transversal force.
3 Recommendations for installation
EN-6