Minebea Intec Novego Manuel D'installation page 45

9 Servicing/repairs/cleaning
EN-43
5. Loosen the screws (4) in the adapter plate (5); next, remove the adapter plate from
the load cell (7).
Note:
Take care to not lose the O-ring (14)!
6. Unscrew the pendulum base (3) from the pendulum pin (9) and remove the O-ring (8).
Note:
Take care to not lose the cap (1)!
The blue coating on the thread is a screw-securing adhesive that can be re-used
multiple times.
7. Mount the new load cell as described in working steps 5-11 in Chapter
Chapter 5.3.2.1.
Hygienic Weighing Module Novego®
5.3.2
Minebea Intec
and 1-2 in