Minebea Intec Novego Manuel D'installation page 36

Masquer les pouces Voir aussi pour Novego:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Hygienic Weighing Module Novego®
Minebea Intec
2. Slowly lower the weighing object (e.g. vessel) including the attached weighing
modules towards the bottom (21). While doing so, align the drill holes of the
pendulum bases (3) over the threaded bars (22).
3. Align the upper plate of the pendulum base (3) using the 0° marking of the lower
plate (see Chapter
5.1.2.2
4. Tighten pendulum base (3) using nut (23). Always comply with the strength classes
and tightening torques of the connector elements (see Chapter 5.2).
It is imperative to observe the maximum permissible inclination; refer to igure!
operating step 10).
5 Installation
EN-34

Publicité

Table des Matières
loading

Table des Matières