Terminal Assignment For Output Signals To The Control Centre (E.g. Plc) (Required For Analogue Output Option Only); Terminal Assignment For Operating Voltage; Terminal Assignment For Connecting The External Position Measuring System (For Remote Model Only); Connection Of The Terminals - Burkert 8791 Manuel D'utilisation

Type 8791
Electrical connection
13.3.3. Terminal assignment for output signals to the control
centre (e.g. plc)
(required for analogue output option only)
terminal configuration
31 + Analogue feedback +
32 – Analogue feedback GND
Table 25: Terminal assignment; output signals to the control centre
13.3.4. Terminal assignment for operating voltage
terminal configuration
+24 V Operating voltage +
GND Operating voltage GND
Table 26: Terminal assignment; operating voltage
13.3.5. Terminal assignment for connecting the external position
measuring system
(for remote model only)
terminal configuration
S + Supply sensor +
S - Supply sensor –
A Serial interface, A cable
B Serial interface, B-cable
Table 27: Terminal assignment; external position measuring system
13.3.6. connection of the terminals
→
Unscrew the 4 screws on the housing cover and remove the cover.
The screw-type terminals are now accessible.
→
Connect terminals according to the configuration.
external circuit / signal level
31 + + (0/4 – 20 mA)
not galvanically isolated
32 – GND
external circuit / signal level
+24 V
GND
external circuit / signal level
S + +
S – –
A A line
B B line
24 V DC ± 10%
max. residual ripple 10%
Remote
Sensor
Typ 8798
english
53