Finish Framing - After Appliance Installation; Framing With Dynamic Heat Control - Napoleon Luxuria Serie Manuel D'installation

finish framing - after appliance installation

11.0 finish framing - after appliance installation
EN

11.1 framing with Dynamic Heat Control™

note:
Appliances can be built in with combustible framing and finishing unless stated.
There are various methods to ventilate the enclosure. Refer to "Dynamic Heat Control™" and "installation
planning" sections.
The appliance must be installed at this point of framing. Appliance is not shown to better illustrate finish framing.
single-sided flush
note:
Finish framing must be built after
appliance has been placed in its final
position and venting connected.
The LVX series requires a minimum
enclosure height, as illustrated (dimen-
sion L), measured from the bottom
of the appliance. For temperature
requirements, this area must be left
unobstructed. Some venting con-
figurations that require more vertical
rise will require a larger enclosure to
provide minimum vertical clearance
between vent pipes and combustibles.
Option 2 illustrated (appliance not shown)
minimum framing
Ref
K 39 15/16" (101.4cm)
E**
F 53 13/16" (136.7cm)
J
L 73" (185.4cm)
Q*
(Q x R)*
* ONLY APPLICABLE TO OPTION 2 AND 3 - Opening must be centered in enclosure on appliance. Dimensions represent
finished sizes and where applicable should be adjusted to include finish material thickness.
**Max. 21" (53.5cm).
52
W415-1710 / B / 08.17.18
Ceiling
LVX38
39 15/16" (101.4cm)
18" (45.7cm) 18" (45.7cm)
65 13/16" (167.2cm)
Optional - Appliance does not need to be elevated above floor
73" (185.4cm)
80 sq. in.
L
Q
J
LVX50 LVX62
39 15/16" (101.4cm)
18" (45.7cm)
77 13/16" (197.6cm)
91" (231.1cm)
2" min and 3" max
R
Drywall
K
E
F
Insulation
LVX74
39 15/16" (101.4cm)
18" (45.7cm)
89 13/16" (228.1cm)
91" (231.1cm)
160 sq. in.