Firebox Glass Door Installation / Removal - Napoleon Luxuria Serie Manuel D'installation

12.7 firebox glass door installation / removal

WARNING
!
• Do not insert fingers in the gap between the door and the door frame, or between the spring latches & door.
there is a risk of injury due to the spring mechanism. Do not insert fingers in the spring door latch mechanism.
FRONT - ACCESS SIDE
Remove the glass guard assembly, refer to the "glass guard installation / removal" section for details.
A.
Remove the door trim by carefully lifting it up and off from behind the bottom frame of the glass door.
B.
Door trim
C. For door removal, locate the top and bottom door latches. Pull latches forwards and away to
disengage door latches.
note:
Ensure to leave one hand on the glass door during entire door removal.
D. Tilt the top of the door forwards 90 degrees, then lift it up and out of the door latches.
E. Reverse these steps to re-install the door, ensure the top and bottom door latches are properly
engaged prior to releasing the door (number of latches varies by size of appliance).
note:
Ensure the door opens freely and closes sealed.
IMPORTANT: Once latches are engaged, test to make sure that the door is sealed.
Side view
Door frame
finishing
LVX38 Illustrated
LVX38 Illustrated
W415-1710 / B / 08.17.18
EN
71