Glass Media Installation / Removal - Napoleon Luxuria Serie Manuel D'installation

Masquer les pouces Voir aussi pour Luxuria Serie:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

12.10 glass media installation / removal

WARNING
!
Clean the glass media prior to installation. Before applying the cleaned glass, ensure that it is dry.
If replacing, use only the replacement glass media available from your local authorized dealer / distributor.
Glass media over the burner ports will cause flame lifting and sooting problems.
Do not place any media (glass or vermiculite) in or around the pilot opening and/or on the burner ports. This
will interfere with the pilot operation.
Evenly spread the glass media onto the media tray. Ensure no glass media falls into the pilot opening. If this
happens, insert a clean bag into your vacuum cleaner and vacuum out the glass media.
Replacement glass can be purchased from your local dealer / distributor.
note:
Do not use more media than what was supplied with the appliance. Do not place media directly onto the burner
(NG models only).
Cleaning Glass Media
Glass media may have a fine oil residue that needs to be cleaned prior to installation. Clean the glass with mild
dish soap, drain, rinse thoroughly and dry before placing over the burner.
Removing Media
Using a vacuum cleaner, use a clean bag and vacuum out the glass media.
note:
Do not place media directly over peaks, see "flame characteristics" section for more information.
This appliance comes equipped with a media tray for sand over top the media tray with
opening for use with all other types of media. Unless, installing sand media, remove the sand
media trays.
note:
Pilot Area
If media trays are not required, remove and install
glass media for best flame and LED appearance.
Natural gas illustrated.
finishing
EN
73
W415-1710 / B / 08.17.18

Publicité

Chapitres

Table des Matières
loading

Table des Matières