2.3.2 Appliance Installation - Napoleon Cinema Serie Manuel D'installation Et D'opération

installation
EN
NOTE: To aid with moving the appliance, leave enough wire so that the appliance can be removed
from the enclosure without disconnecting the power supply. If servicing, shut off power supply.

2.3.2 appliance installation

NOTE: This appliance is equipped with nylon pads located on the bottom four corners. To prevent
damaging the base of the mantel, carefully lift the appliance into the mantel while avoiding contact
with the front edge of the mantel base.
With two people, lift the appliance up and insert into the opening, keeping a 3/8" (9.5mm) space between
A.
the appliance and floor base in order to not scratch the floor surface. Do not push or slide the bottom of
the appliance on the floor base, see Figure 1.
Set the appliance down and into place, see Figure 2.
B.
If the appliance does not sit flat on the floor or mantel base, apply a shim (not supplied) under the nylon
C.
pads and adjust until level.
Fig. 1
STEP 1: LIFT
ÉTAPES 1: SOULEVER
APPLIANCE
APPAREIL
12
W415-1662 / C / 07.20.20
F
J
I
U
R (L1)
BLACK
N
E
C
P
WHITE (N)
T
L
I
A
GREEN (G)
O
C
N
WIRE NUT
E
MANTEL
MANTEL
TABLETTE
F
J
STEP 2: INSERT
I
ÉTAPES 2: INSÉREZ
U
BLACK (L1)
R
N
E
C
P
T
L
WHITE (N)
I
A
O
C
DO NOT SLIDE APPLIANCE
!
N
NE GLISSEZ PAS L'APPAREIL
E
F
1/4"
GROUND
MANTEL
STEP 1: LIFT
ÉTAPES 1: SOULEVER
APPLIANCE
APPAREIL
1/4"
Fig. 2
WIRE NUT
!
MANTEL
TABLETTE
S
P
U
BLACK
O
P
W
P
WHITE
E
L
R
Y
GREEN
STEP 2: INSERT
ÉTAPES 2: INSÉREZ
F
J
I
U
R
RED
MARRET
N
E
C
P
T
L
RED
I
A
O
DO NOT SLIDE APPLIANCE
! !
C
N
NE GLISSEZ PAS L'APPAREIL
E
GREEN
MANTEL
MANTEL
TABLETTE
BLACK
APPLIANCE
APPAREIL
STEP 3: SET APPLIANCE
ÉTAPES 3: RÉGLÉ APPAREIL
BLACK
(L1)
WHITE
(N)
WALL
SWITCH
POWER
SUPPLY