Glass Guard Installation / Removal - Napoleon Luxuria Serie Manuel D'installation

finishing
EN

12.6 glass guard installation / removal

WARNING
!
• The polystyrene / styrofoam packaging materials may scratch the glass if the GGA is not covered by the
plastic layer.
• Adequate steps must be taken to protect the appliance and Dynamic Heat Control™ (DHC) openings from
dirt, debris and damage during finishing.
• The GGA installation and/or removal will require 2 people.
• The GGA should be preliminarily fitted and adjusted before finish framing and finishing the appliance. It is
much easier to make adjustments with the appliance pre-finishing access panel removed. It is recommended
that the GGA is removed after preliminary adjustment and stored safely in the original packaging whilst
finishing is complete. Take precautions to protect the appliance during finishing.
Rear view of GGA
THIS WAY UP
Access side view of appliance
62
W415-1710 / B / 08.17.18
Key Components
• Outer glass
• Horizontal tab
• Napoleon logo
(affixed to
intermediate glass)
• GGA catch
• GGA catch
securing screws
• Intermediate glass
• GGA mount
bracket
Fig. 1
• Latch
• GGA slider bracket
Fig. 2