Mobile Home Installation; Hardware List; Lifting Handles Installation/Removal - Napoleon Luxuria Serie Manuel D'installation

1.5

mobile home installation

This appliance must be installed in accordance with the manufacturer's instructions and the Manufactured
Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the United States or the Mobile Home
Standard, CAN/CSA Z240 MH Series, in Canada. This appliance is only for use with the type(s) of gas
indicated on the rating plate.
This mobile/manufactured home listed appliance comes factory equipped with a means to secure the appliance. The
shipping brackets that secure the appliance to the pallet can be used to secure the appliance to the floor for mobile
home installation. For mobile home installations, the appliance must be fastened in place.
This appliance is certified to be installed in an aftermarket permanently located, manufactured (mobile) home,
where not prohibited by local codes.
This appliance is only for use with the type of gas indicated on the rating plate. This appliance is not convertible
for use with other gases, unless a certified kit is used.
Conversion Kits
This appliance is field convertible between Natural Gas (NG) and Propane (P). Propane not available for LVX74
models.
To convert from one gas to another, consult your Authorized dealer/distributor.
1.6

hardware list

1
Hex Head Sheet Metal Screw
1
2 Pan Head Sheet Metal Screw
Hex Head Sheet Metal Bolt
3
1.7

lifting handles installation/removal

Remove 4 screws each side (8 total) then install the
lifting handles to the side of the appliance and secure
using 4 screws each side (8 total). Once the appliance
is in place remove the four screws from each handle to
the appliance. Discard the lifting handles.
note:
The lifting handles MUST be removed prior to rough
framing the appliance.
2
Description
note:
Only fasteners supplied with the appliance are illustrated.
general information
Quantity
LVX38 LVX50 LVX62
22 22 22
4 4 4
18 18 18
EN
3
LVX74
22
4
18
11
W415-1710 / B / 08.17.18