CAMPAGNOLO BORA WTO Manuel De L'utilisateur page 28

3 - T I R E S
• Carry out the same operations on the other side of
the tyre (Fig. 20 and 21).
Note
Completely remove one side of the tyre before
going on to the other side.
• Lift off the tyre (Fig. 22).
20 21 22
3. 4 - CH E CK ING T HE T I G HT NE SS O F THE TUBE L E SS SY STEM (TUBE LESS RIM + TUBELESS T YRE)
Check that the tyre and rim are in good condition.
• Check that the inside of the tyre and rim are perfectly clean; clean them with a cloth if necessary.
• Inflate the tyre to the working pressure and immerse the wheel with its tyre in a basin of water to check for cuts or punctures. Replace the tyre if necessary.
• If the leakage occurs in the valve zone, check:
- that the valve is that which is indicated in the Spare Parts Catalogue, which can be found at the website www.campagnolo.com
- that the valve is screwed onto the adapter properly.
- that the ring is securely tightened. If the leakage persists, replace both of them
If the leakage occurs between the bead and the edge of the rim, disassemble the tyre, make sure that there are no cuts or punctures and repeat assembly.
If after all these checks the tightness of the Tubeless system is still not satisfactory, contact your nearest Campagnolo dealer.
11
CAMPAGNOLO.COM