CAMPAGNOLO BORA WTO Manuel De L'utilisateur page 21

2-Way Fit rims are designed for both tubeless / tubeless ready and standard clinchers.
• Before fitting the tyres check that the diameter indicated on the tyre is 622
mm and that the width of the tyre is compatible with the width of the rim as
indicated in the rim/tyre compatibility table on page 3.
WARNING!
RIM-TIRE COMPATIBILITY
• All Campagnolo rims are made with very precise dimensionally. If a
tire is too easy to install on a Campagnolo rim, that tire is most likely
too big and will not seat properly on the rim. If a tire is too difficult to
install, that tire is most likely too small. Use only high quality tires that
require the use of tire levers and a reasonable installation effort. Using
talcum powder on the tire will make installation easier. Using a tire that
does not fit properly on the rim can cause sudden and unexpected tire
failure, resulting in an accident, personal injury or death.
• Incorrect rim / clincher tyre coupling may cause it to deflate, burst or
detach suddenly and cause accidents, serious injuries or even death.
• Failure to properly install the tire can cause sudden and unexpected
loss of tire pressure, resulting in an accident, personal injury or death.
Be sure that you do not damage or otherwise bend any portion of the rim
when installing the tire. Be careful not to damage or bend any part of the
rim when mounting the tyre. Damaging the edge of the rim can compromise
its operation, especially when using tubeless tyres. Check that the inside of
the tyre and rim are perfectly clean; clean them with a cloth if necessary.
WARNING: If you are unable to fit and remove the tyres by hand use
plastic tyre levers (never use metallic levers because you could dama-
ge the rim and the tyre).
4
3 - T I R E S
3. 1 - IN STALLIN G C LIN CHER T IRE S
• Fit the first bead of the tyre into the rim groove (Fig. 1) starting from the point opposite
the valve.
• Introduce a partially inflated presta inner tube into the tyre (Fig. 2).
TYRE
RIM
1
CAMPAGNOLO.COM
BEAD
2