Assembly And Installation - Yamaha TT-R125Y 2009 Manuel D'atelier

FRONT BRAKE (TT-R125LW/TT-R125LWE)

ASSEMBLY AND INSTALLATION

WARNING
• All internal parts should be cleaned in new
brake fluid only.
• Internal parts should be lubricated with
brake fluid when installed.
• Replace the brake caliper piston seals and
brake caliper dust seals whenever a brake
caliper is disassembled.
Brake caliper piston
1. Clean:
• Brake caliper
• Brake caliper piston seal
• Brake caliper dust seal
• Brake caliper piston
Clean them with brake fluid.
2. Install:
• Brake caliper piston seal 1
• Brake caliper dust seal 2
WARNING
Always use new brake caliper piston seals
and brake caliper dust seals.
TIP
Fit the brake caliper piston seals and brake
caliper dust seals onto the slot on brake caliper
correctly.
3. Install:
• Brake caliper piston 1
TIP
Apply the brake fluid on the brake caliper piston
wall.
NOTICE
• Install the brake caliper piston with its
shallow depressed side a facing the
brake caliper.
• Never force to insert.
Brake caliper
1. Install:
• Sleeve boot 1.
On brake caliper bracket 2.
5-17
CHAS
New
New