Publicité
FRONT BRAKE SHOE INSPECTION
(TT-R125/TT-R125E)
• Connect the transparent hose 4 to the bleed
screw 5 and place the suitable container
under its end.
• Loosen the bleed screw and push the brake
caliper piston in.
NOTICE
Do not reuse the drained brake fluid.
• Tighten the bleed screw.
Bleed screw:
6 Nm (0.6 m · kg, 4.3 ft · lb)
• Install the brake caliper 6 and brake caliper
support bolt 7.
TIP
Apply the lithium soap base grease on the
caliper support bolt
Brake caliper support bolt:
22 Nm (2.2 m · kg, 16 ft · lb)
4. Inspect:
• Brake fluid level
Refer to "BRAKE FLUID LEVEL INSPEC-
TION" section.
5. Check:
• Brake lever operation
A softy or spongy feeling → Bleed brake
system.
Refer to "BRAKE SYSTEM AIR BLEED-
ING" section.
FRONT BRAKE SHOE INSPECTION
(TT-R125/TT-R125E)
1. Inspect:
• Brake shoe lining wear limit
Brake shoe lining wear limit checking
steps:
• Fully pull in the brake lever and hold it in
position.
• Then check the brake shoe wear indicator
1 is within the wear limit a.
Outside the limit → Replace the brake shoe.
Refer to "FRONT WHEEL AND FRONT
BRAKE" section in the CHAPTER 5.
3-19
INSP
ADJ
Publicité
Chapitres
