Publicité
VALVE CLEARANCE INSPECTION AND
ADJUSTMENT
4. Check:
• Valve clearance
Out of specification → Adjust.
Valve clearance (cold):
Intake valve:
0.08 ~ 0.12 mm
(0.0031 ~ 0.0047 in)
Exhaust valve:
0.10 ~ 0.14 mm
(0.0039 ~ 0.0055 in)
Checking steps:
• Turn the crankshaft counterclockwise with
a wrench.
• Align the T.D.C. mark a on the rotor with
the align mark b on the crankcase cover
when piston is at T.D.C. on compression
stroke.
• Measure the valve clearance using a feeler
gauge 1.
Out of specification → Adjust clearance.
5. Adjust:
• Valve clearance
Adjustment steps:
• Loosen the locknut 1.
• Turn the adjuster 3 in or out with the valve
adjusting tool 2 until specified clearance is
obtained.
Turning in →
Valve clearance is decreased.
Turning out →
Valve clearance is increased.
Tappet adjusting tool:
YM-8035/90890-01311
• Hold the adjuster to prevent it from moving
and tighten the locknut.
Locknut:
8 Nm (0.8 m · kg, 5.8 ft · lb)
3-12
INSP
ADJ
Publicité
Chapitres
