Electrical Connection On Finished Walls; Connecting A Load Shedding Relay; Water Installation On Finished Walls - Stiebel Eltron DHE Connect 18 Utilisation Et Installation

INSTALLATION
Alternative installation methods

14.3 Electrical connection on finished walls

Note
This type of connection changes the IP rating of the ap-
pliance.
f Change the type plate. Cross out "IP 25" and mark f
the box "IP 24". Use a ballpoint pen to do this.
30
1 Cable grommet
f Prepare the power cable. Fit the cable grommet. f
Material losses
!
Use a new back panel or appliance cover if you break
out the wrong hole in the back panel or appliance cover
by mistake.
f Cleanly cut and break out the required cable entries in the f
back panel and appliance cover (for the positions, see chap-
ter "Specification / Dimensions and connections"). Deburr any
sharp edges with a file.
104 |DHE Connect | DHE Touch
160
1
f Route the power cable through the cable grommet. f
f Connect the power cable to the mains terminal. f

14.4 Connecting a load shedding relay

Install a load shedding relay in the distribution board in conjunc-
tion with other electric appliances, e.g. electric storage heaters.
The relay responds when the instantaneous water heater starts.
Material losses
!
Connect the phase that switches the load shedding relay
to the indicated terminal of the mains terminal in the
appliance (see chapter "Specification / Wiring diagram").

14.5 Water installation on finished walls

Note
This type of connection changes the IP rating of the ap-
pliance.
f Change the type plate. Cross out "IP 25" and mark f
the box "IP 24". Use a ballpoint pen to do this.
www.stiebel-eltron.com