Recommissioning; Shutdown; Installation Options; Electrical Connection From Above On Unfinished Walls - Stiebel Eltron DHB-E 11 SLi electronic Utilisation Et Installation

INSTALLATION

Shutdown

11.2 Recommissioning

Material losses
!
To ensure that the bare wire heating system is not dam-
aged following an interruption to the water supply, the
appliance must be restarted taking the following steps.
f Disconnect the appliance from the power supply by f
removing the fuses/tripping the MCBs.
f Open the tap for one minute until the appliance and f
its upstream cold water inlet line are free of air.
f Switch the mains power back ON again. f
12. Shutdown
f Isolate all poles of the appliance from the power supply. f
f Drain the appliance (see chapter "Installation / Maintenance / f
Draining the appliance").

13. Installation options

13.1 Electrical connection from above on unfinished
walls
f Cut open the cable grommet for the power cable. f
f Push down the locking hook for securing the mains terminal. f
Pull out the mains terminal.
f Reposition the mains terminal in the appliance from the bot- f
tom to the top. Secure the mains terminal by sliding it under
the locking hook.
f Route the control wires under the wire guide. f
30 | DHB-E SLi

13.2 Electrical connection on finished walls

Note
This type of connection changes the protection rating of
the appliance.
f Change the type plate. Cross out "IP 25" and mark f
the box "IP 24". Please use a ballpoint pen to do this.
Material losses
!
If you break open the wrong knock-out in the back panel
by mistake, you must use a new back panel.
f Cleanly cut or break out the required cable entry in the back f
panel (for positions, see chapter "Installation / Specification /
Dimensions and connections"). Deburr sharp edges with a
file if necessary.
f Route the power cable through the cable grommet. Connect f
the power cable to the mains terminal.
13.3 Large conductor cross-section for electrical
connection from below
If you use cables with a large cross-section, you can fit the cable
grommet after the appliance has been installed.
1.
3.
f Before installing the appliance, use a screwdriver to push out f
the cable grommet.
f Slide the cable grommet over the power cable. Use the f
installation aid supplied in the standard delivery. If the
cross-section is > 6 mm², enlarge the hole in the cable
grommet.
f Push the cable grommet into the back panel. Click the cable f
grommet into place.
2.
4.
www.stiebel-eltron.com