Fitting Appliance Cover For Water Installation On; Finished Walls; Lower Back Panel Section Installation With Threaded Fittings On Finished Walls - Stiebel Eltron DHE Connect 18 Utilisation Et Installation

INSTALLATION
Alternative installation methods

14.7 Fitting appliance cover for water installation on

finished walls

4
3
2
1
1 Back panel guides
2 Screw
3 Cover guides with sealing lips on the pipe side
4 Pipe knock-out
f Cleanly saw and break out the pipe knock-outs in the appli- f
ance cover. If necessary, use a file.
f Click the cover guides into place in the knock-outs. f
Only if using the "solder fitting" accessory and with precise
adherence to all installation dimensions:
f Break the sealing lips out of the cover guides. f
f Position the back panel guides on the pipes. Push them to- f
gether. Then push the guides against the back panel as far
they will go.
106 |DHE Connect | DHE Touch
f Secure the lower back panel section with a screw. f
Note
You can use the cover guides with sealing lips to com-
pensate for a slight offset of the connection pipes and/
or if using the "press fitting" accessory. In this case, the
back panel guides are not fitted.
14.8 Lower back panel section installation with
threaded fittings on finished walls
3
1
1 Lower back panel section
2 Connection piece in the standard delivery
3 Screw
If using threaded fittings on finished walls, the lower back panel
section can also be installed after fitting the taps. To do this, carry
out the following steps:
f Cut open the lower back panel section. f
2
www.stiebel-eltron.com