Installing Filter Cabinet - Miller FILTAIR SWX-D Mode D'emploi

5-7. Installing Filter Cabinet

5
! Installation must meet all National,
State, and Local Codes − have only
qualified persons make this installa-
tion.
! Do not use this equipment to sup-
port personnel, large tools, or other
material.
! Be sure the mounting hardware and
the wall or other structure will sup-
port the weight of the equipment.
NOTICE − To avoid damaging filter cabinet
during installation, use the attached ship-
4
ping pallet to lift unit. Remove pallet after
completing installation.
1 Mounting Bracket (Installed On
Support Structure − Section 5-4)
2 Cabinet Forks
3 Ear Tabs
4 Filter Cabinet
5 Locking Screw
Using attached shipping pallet, lift filter cab-
inet so cabinet forks are above the mount-
ing bracket. Lower the cabinet until both
See Section
5-4 for mounting
bracket installation.
1
Tools Needed:
forks are seated on bracket and within
bracket ear tabs.
Tighten the two locking screws to secure
cabinet on bracket. Remove shipping pal-
let.
6 Particle Collection Tray (Not Shown)
(SWX-S Self-Cleaning Models Only)
Install particle collection tray in tracks at
bottom of cabinet. (Make sure the tray's
small corners slide in first.) Secure tray by
closing the four side latches.
OM-246877 Page 19
2
3
1/2 in.
248 231