Overload Protection - Miller FILTAIR SWX-D Mode D'emploi

7-2. Overload Protection

Control Panel − SWX-S (Self-Cleaning) Models Only
1
Blower Control − All Models
!
.
1
CB1 protects the blower motor from
overload. If CB1 opens the blower motor
will not run.
To access CB1, remove cover from
blower control .
To reset CB1, place CB1 in the On (up)
position.
2
F1 protects the electrical components of
the filter cleaning system from overload.
If F1 opens the filter cleaning system
does not operate.
To access F1, open door on control
panel.
Check fuse, and replace if open. Close
door.
2
Disconnect and lockout/tagout
input power before connecting
input conductors from unit. Fol-
low established procedures re-
garding the installation and re-
moval of lockout/tagout devices.
If a fuse or circuit breaker opens, it
usually indicates a more serious
problem exists. Contact a Factory
Authorized Service Agent.
Circuit Breaker CB1 (All Models)
Fuse F1 − SWX-S Models Only
(See Parts List For Rating)
Tools Needed:
Fuse Puller
248 032
OM-246877 Page 31