Installing And Aligning Wire Guide And Drive Roll - Miller Super S-32P Ultra-Lite Mode D'emploi

3-2. Installing And Aligning Wire Guide And Drive Roll

Tools Needed:
3/16 in
3/8 in
Alignment
OM-184 517 Page 12
5
4
3
1 2
When changing wire size or type,
check drive roll and wire guide size
(see Parts List).
Installing Wire Guide And Drive
Rolls:
1 Drive Roll Nut
2 Drive Roll Carrier
Turn nut one click until lobes of nut
line up with lobes of drive roll carrier.
3 Drive Roll
Slide drive roll onto drive roll carrier.
Turn nut one click.
Repeat procedure for top drive roll.
4 Inlet Wire Guide Screw
5 Inlet Wire Guide
Loosen securing screw. Install inlet
guide so inlet guide screw is
centered in groove in guide, or so tip
is as close to drive rolls as possible
without touching. Tighten screw.
Aligning Wire Guide And Drive
Rolls:
Only top drive roll alignment is ad-
justable. Turn adjustment screw in
or out until groove in drive roll lines
up with wire guide as shown.
Cleaning Drive Rolls:
Remove drive rolls, and clean
grooves using a wire brush.
ST-132 809-B / Ref. ST-132 808-F / Ref. ST-162 079-A / Ref. S-180 967