Installing Electrode Holder And Work Clamp - Miller Thunderbolt XL Manuel Du Propriétaire

5-3. Installing Electrode Holder And Work Clamp

4
1
9
7
.
A complete Parts List is available at www.MillerWelds.com
3
2
6
PIECE
!
Turn Off unit and disconnect
input power before installing
electrode holder or work
clamp.
Removing Barrel From Elec-
trode Holder
1 Electrode Holder
2 Barrel
3 Access Hole
4 Set Screw
Loosen set screw through access
hole and slide barrel away from
electrode holder.
5
Installing Electrode Cable and
Barrel onto Electrode Holder
5 Electrode Cable From Unit
(Has Bare Conductors on
End)
6 Terminal Screw
Back out terminal screw from elec-
trode holder. Insert electrode cable
through barrel into end of electrode
holder and tighten terminal screw
securely.
Move barrel toward electrode hold-
er and tighten set screw to secure
barrel in place.
Installing Work Cable onto Work
Clamp
7 Work Clamp
8 Work Cable From Unit (Has
Ring Terminal on End)
9 Mounting Bolt
Route work cable through work
clamp as shown and install onto
mounting bolt using supplied hard-
ware.
8
Tools Needed:
14 mm
6 mm
Ref. 802 251-A / 802 105-D
OM-316 Page 17