Table des Matières
Publicité
3-3. Volt-Ampere Curves
3-4. Installing Power Cord (CE Models Only)
Tools Needed:
1/4, 11/32 in
2
1
Brown Lead
Bottom Rear
5
3
The volt-ampere curves show the
minimum and maximum voltage
and amperage output capabilities of
the welding power source. Curves
of other settings fall between the
curves shown.
Remove base plate.
1
Y Be sure conductor rating of
Install ring terminals on all three
conductors.
2
3
4
Route power cord through strain re-
lief and connect green/yellow pow-
er cord grounding lead to ground
terminal where existing grounding
lead is already attached.
5
Green/Yellow Lead
Connect line input conductors to
Blue Lead
the two open (outside) line termi-
nals on the filter.
Tighten strain relief.
Install base plate
4
ssb1.1 10/91 – SB-151 604
User-Supplied Power Cord
cord complies with national
and local electrical codes.
Strain Relief Connector
Filter
Ground Terminal
Line Terminals
ST-801 603 / 802 436
OM-172 200 Page 13
Publicité
Table des Matières
Dépannage
