Sun Microsystems Netra CT 900 Guide D'administration Et D'utilisation page 69

Table des Matières

Publicité

Fichier shelfman.conf par défaut (suite)
EXEMPLE DE CODE 2-1
# REDUNDANT_IP_ADDRESS: This parameter specifies the IP address for network
# adapter used for redundant communications. This address actually provides
# a pair of IP addresses that differ in the least significant bit. They are
# assigned to redundant ShMs according to their hardware addresses, so they
# are equal on both ShMs. This parameter has no default value and must
# always be set.
#
REDUNDANT_IP_ADDRESS = $IP1ADDR
# REDUNDANCY_NETMASK: This parameter sets the network mask for the network
# adapter used for redundancy communications. Default is 255.255.255.0
#
# REDUNDANCY_NETMASK = 255.255.255.0
# RMCP_NET_ADAPTER: This parameter specifies the name of network adapter
# used for RMCP-based communications. Default is eth0:1 if it does not
# conflict with REDUNDANCY_NET_ADAPTER.
#
RMCP_NET_ADAPTER = $IPDEVICE
# RMCP_NET_ADAPTER2:
This parameter specifies the alternate name of network
# adapter used for RMCP-based communications, if cross-connect links are
# supported by hardware.
Undefined by default.
#
#RMCP_NET_ADAPTER2 = "eth1"
# DEFAULT_RMCP_IP_ADDRESS: This parameter specifies the default IP address
# for network adapter used for RMCP communications. It is switched over
# between redundant instances of the Shelf Manager. This address is only
# used if no IP address is set in the LAN Configuration Parameters for
# channel # 1. Default is the REDUNDANT_IP_ADDRESS parameter value.
#
DEFAULT_RMCP_IP_ADDRESS = $RMCPADDR
# PROPAGATE_RMCP_ADDRESS: This parameter specifies whether the RMCP IP
# address should be propagated to the backup Shelf Manager. If set, the
# backup Shelf Manager configures its network interface specified by
# RMCP_NET_ADAPTER using given IP address with the least significant bit
# inverted. Default is FALSE.
#
PROPAGATE_RMCP_ADDRESS = FALSE
# DEFAULT_RMCP_NETMASK: This parameter specifies the network mask for
# network adapter used for RMCP communications. Default is 255.255.255.0
Chapitre 2 Configuration de votre système
47

Publicité

Table des Matières
loading

Table des Matières