Table des Matières
Publicité
Le gestionnaire d'étagère peut être réinitialisé aux valeurs d'usine des paramètres si
nécessaire. L'
EXEMPLE DE CODE 2-1
défaut :
EXEMPLE DE CODE 2-1
# /etc/shelfman.conf
#
# This is the PPS Shelf Manager configuration file.
# Copyright (c) 2005 Pigeon Point Systems.
# All rights reserved.
#
# CARRIER: This parameter is the name of the carrier-specific module to use.
#
Default is PPS.
CARRIER = $CARRIER
# CARRIER_OPTIONS: This parameter specifies the carrier-specific options.
#
Default is an empty string.
CARRIER_OPTIONS = $CARRIER_OPTIONS
# ALTERNATE_CONTROLLER: This parameter of boolean type specifies whether to
#
use the alternate controller on the Shelf Manager with the address
#
equal to the ShM hardware address. Default is TRUE.
#
ALTERNATE_CONTROLLER = TRUE
# ALLOW_CLEARING_CRITICAL_ALARM: This parameter of boolean type enables the
#
ability to clear the critical alarm condition without the alarm cutoff
#
button. Default is FALSE.
#
ALLOW_CLEARING_CRITICAL_ALARM = FALSE
# ALARM_CUTOFF_TIMEOUT: This parameter specifies the time interval in
# seconds for the Shelf Manager to hold the Alarm Cutoff state. Default
# interval is 600 seconds.
#
ALARM_CUTOFF_TIMEOUT = 600
# COOLING_IGNORE_LOCAL_CONTROL: This parameter of boolean type specifies
#
whether the Shelf Manager should use local control capabilities on fan
#
devices i.e. whether the Shelf Manager should explicitly manage fan
#
levels or not. Default is FALSE.
#
COOLING_IGNORE_LOCAL_CONTROL = FALSE
# COOLING_POLL_TIMEOUT: This parameter specifies the maximum time (in
présente une copie du fichier de configuration par
Fichier shelfman.conf par défaut
Chapitre 2 Configuration de votre système
41
Publicité
Chapitres
Table des Matières
