Sun Microsystems Netra CT 900 Guide D'administration Et D'utilisation page 68

Fichier shelfman.conf par défaut (suite)
EXEMPLE DE CODE 2-1
# equal Shelf FRU Information instances that must be found to determine the
# true Shelf FRU Information. Default is 2.
#
MIN_SHELF_FRUS = 2
# EXIT_IF_NO_SHELF_FRU: This parameter of boolean type tells the Shelf
# Manage if it should exit if no valid Shelf FRU Information data is found.
# Default is FALSE.
#
EXIT_IF_NO_SHELF_FRU = FALSE
# VERIFY_SHELF_FRU_CHECKSUM: This parameter boolean type specifies whether
# the Shelf FRU Information record checksums should be validated. The
# default is TRUE.
#
VERIFY_SHELF_FRU_CHECKSUM = TRUE
# WATCHDOG_ENABLED: This parameter of boolean type tells the Shelf Manager
# whether it should use the hardware watchdog timer supported by the CPLD or
# not. The default is TRUE.
#
WATCHDOG_ENABLED = TRUE
# REDUNDANCY_ENABLED: This parameter of boolean type tells Shelf Manager if
# it should run in redundant mode or not. Default is TRUE.
#
REDUNDANCY_ENABLED = TRUE
# REDUNDANCY_PORT: The parameter specifies the TCP port number used for
# inter-host communications by redundant instances of the Shelf Manager.
# Default is 1040.
#
REDUNDANCY_PORT = 1040
# REDUNDANCY_NET_ADAPTER: This parameter specifies the name of network
# adapter used for communication between redundant ShMMs. Default is eth0 if
# it does not conflict with RMCP_NET_ADAPTER.
#
REDUNDANCY_NET_ADAPTER = $IP1DEVICE
# REDUNDANCY_NET_ADAPTER2: This parameter specifies the name of the second
# network adapter used for communication between redundant ShMMs (if USB
# interface is used for redundancy). By default, this parameter is not
# defined.
#REDUNDANCY_NET_ADAPTER2 = "usb1"
46 Guide d'administration système du serveur Netra CT 900 • Janvier 2007