Remote Control - EdilKamin QUEBEC Installation, Usage Et Maintenance

REMOTE CONTROL

This controls all the functions. It is necessary to point it directly at the thermo stove.
For further information contact our customer service centre.
Key to buttons and display:
:
ignition / shutdown button (press for approximately 1 second) this button can also be pressed to exit the
programming menu
+
:
button to increase the power/operating temperature (when inside a menu, it increases the displayed variable)
-
:
button to decrease the power/operating temperature (when inside a menu, it decreases the displayed variable)
A :
button to switch to the "EASY TIMER " program
M :
key for viewing/setting the set temperature (Set 70°C) and the kg of consumed pellets (Pellt KG. UTE 200)
INSTRUCTIONS FOR USE
(QUEBEC/TORONTO/MONTREAL/DETROIT/BOSTON/MIAMI)
Indicates data transmission between the remote con-
trol and the control board.
low batteries; replace them and put them in their
appropriate containers.
blocked keypad; avoid turning on the remote control for no
reason (press "A" and "M" simultaneously for a few
seconds to block/unblock the keypad)
Indicates that ignition / shutdown is being via
the "EASY TIMER" program
Indicates the room temperature detected by the remote
control (it indicates the values of the set parameters
during its technical set-up).
On icon: thermo stove in start-up/operating phase
Indicates that the flow temperature can be set manually
pellet/water thermo-stoves remote control
setting indicator
47