B.1.1 The Keypad - AOIP CP6632 Mode D'emploi

CP6632
Devices with product code CP6632 or WEM41020-000 or WEM41020-000A :
After inserting the dry cells (or NiMH batteries) correctly, press the ON/OFF
key until the first " Checking EEPROM" screen comes up.
To turn the unit off, press the ON/OFF key until the "Instrument in standby
mode" screen comes up.
Allow about ten seconds between phases.
Devices with product code WEM41020-000B :
After inserting the dry cells (or NiMH batteries) correctly, press the ON/OFF
key until the first screen comes up ("Checking EEPROM" or "Product name" or
"Product name + logo", following the software version).
To turn the unit off completely, press the ON/OFF key until the "Instrument in
power off mode" screen comes up. In this case, the Date + Time are lost.
In standby mode, the Time is retained. To go to standby mode, press both
the HOLD and ON/OFF keys until the " Instrument in standby mode " screen
comes up. To return to normal operating mode, again press the ON/OFF key
st
until the 1 screen comes up.
Allow about ten seconds between phases.
The product code is located on the bottom code label at the back of the unit.
unit.

B.1.1 The keypad

The keypad:
•
2 function keys (F1 and F2) for selecting the different menus
displayed on the screen.
• The navigator consisting of 4 arrows (up (↑ ↑ ↑ ↑ ), down (↓ ↓ ↓ ↓ ), right ( ),
left (    )
•
A cancel key (CLEAR).
•
A key for switching the instrument and the backlighting on and off
(ON/OFF).
When in operation, one short press switches the lighting on or off.
•
A validation key (VAL).
•
A HOLD key allows the temporary stopping of a process (short
press).
12/47
U
SING THE INSTRUMENT