C.1.5 Ramp Signal Generation Configuration - AOIP CP6632 Mode D'emploi

CP6632

C.1.5 Ramp signal generation configuration

The CONFIGURATION/RAMP menu is used for the generation of incremental,
single or cyclic ramp signals in both voltage and current.
Incremental ramp signal configuration?
The figure below shows the type of single ramp signal that can be generated
along with its parameters:
Programming parameters in Incremental mode
INC
T0
Tdt
To : The moment the start of generation key is pressed
Td : Delay
Tdt : Duration
NB : Low Level
NH : High Level
INC: Increment (value of the increments in %, Volt or mA)
The LOW Level and HIGH level are given:
•
As a percentage of the range if scaling mode is ON.
•
In volts or mA if the scaling mode is OFF and depending on the type
of quantity transmitted (voltage or current transmission).
The Duration corresponds to the incrementation time it takes to go from
Low Level to High Level (and vice versa with decrementation). It is given in
seconds and is limited to a maximum of 1000s.
The Delay corresponds to the timeout that can be programmed between the
moment the start of transmission key is pressed and the actual start of
generation. It is given in seconds and is limited to a maximum of 1000s.
30/47
P
ROGRAMMING THE MODES
NH
NB
Td
T0
Tdt
Td
T0
Tdt