Entering The Correction Factor Of The Fitting Used - Burkert 8228 Mode D'emploi

Operatingandcommissioning
9.8

entering the correction factor of the fitting used

The correction factor depends on the shape, the material and the diameter of the fitting used. The following table gives the correction factors
of the fittings S020.
→
From the Process level, access the Configuration level.
→
Access the menu "Calib".
→
Go to the function "K-fitting".
Calib Sensor
→
Confirm the function "K-fitting".
→
Enter the correction factor of the fitting used.See Table 1.
Table 1: Correction factors of the fittings S020, depending on the shape, the material and the DN of the fittings
Fittings with true union connections
or fittings with weld ends
PVDF PP
DN
<32 1,08 1,08
32 1,08 1,08
40 1,04 1,04
50 1,02 1,02
65 - -
80 - -
100 - -
>100 - -
Type 8228
Probe
K-fitting
Fittings with internal or external
thread connections or fittings with
weld end connections
PVC Brass
1,08 0,99
1,08 0,99
1,04 0,99
1,02 0,99
- -
- -
- -
- -
Measurement
chamber
Stainless steel
0,99 -
0,99 0,99
0,99 0,99
0,99 0,99
- -
- -
- -
- -
Welding sockets or fusion spigots
Stainless steel PVDF
- -
- -
- -
0,99 -
0,99 1,02
0,99 1,02
1,00 1,02
1,00 1,00
English
PP
-
-
-
-
1,02
1,02
1,02
1,00
27