Installation And Wiring; Safety Instructions - Burkert 8228 Mode D'emploi

8

insTAllATion AnD WirinG

8.1

safety instructions

danger
danger due to electrical voltage.
▶ Shut down the electrical power source of all the conductors and
isolate it before carrying out work on the system.
▶ All equipment connected to the 8619 shall be double insula-
ted with respect to the mains according to the standard IEC
61010-1:2010.
▶ Observe all applicable accident protection and safety regula-
tions for electrical equipment.
risk of injury due to high pressure in the installation.
▶ Stop the circulation of fluid, cut off the pressure and drain the
pipe before loosening the process connections.
risk of injury due to high fluid temperatures.
▶ Use safety gloves to handle the device.
▶ Stop the circulation of fluid and drain the pipe before loosening
the process connections.
risk of injury due to the nature of the fluid.
▶ Respect the regulations on accident prevention and safety relat-
ing to the use of aggressive fluids.
14
English
Type 8228
Installationandwiring
Warning
risk of injury due to non-conforming installation.
▶ The electrical installation can only be carried out by qualified and
skilled staff with the appropriate tools.
▶ The electrical and fluid installation can only be carried out by
qualified and skilled staff with the appropriate tools.
▶ Install appropriate safety devices (correctly rated fuse and/or
circuit-breaker).
▶ Observe mounting instructions of the fitting.
risk of injury due to unintentional switch on of power supply
or uncontrolled restarting of the installation.
▶ Protect the installation against unintentional power-up.
▶ Guarantee a set or controlled restarting of the process subse-
quent to any intervention on the device.
Warning
risk of injury if the fluid pressure/temperature dependency is
not respected.
▶ Observe the fluid temperature-pressure dependency according to
the material of the conductivity sensor holder (see the technical data
of the device) and according to the materials the fitting is made of
(see the operating instructions of the fitting used).
▶ Observe the Pressure Directive 97/23/CE.
Protect this device against electromagnetic interference,
ultraviolet rays and, when installed outdoors, the effects of the
climatic conditions.