Instructions For Normal Operation; Visualizing The State Of The Pan & Tilt; Saving A Preset; Quick Save - Videotec Ulisse Compact Manuel D'instructions

10 Instructions for normal
operation
Direct and prolonged shooting of the
sun by the thermal camera can cause
irreparable damage to its sensor.
10.1 Visualizing the state of the
pan & tilt
During normal operation the pan & tilt displays
on screen, at user's choice, the data organized as
illustrated. The visualization can be enabled or
disabled (8.1.11 Display Menu, page 39).
NORTH/EAST
ID: 1
AL 1: Alarm 1
Pan : - 5.56
Tilt: +120.01
Zoom: 36.00x
Preset: Text 001
E7-PRESET NOT CONFIGURED
Fig. 91
NORTH/EAST: Name of the area where one is
currently located.
ID: 1: Receiver's address.
12345: Complete list of active alarms.
AL 1: Alarm 1: Text regarding the last active alarm.
Pan: - 5.56/Tilt: +120.01/Zoom: 36.00x: Current
position of Pan, Tilt and Zoom.
Preset: Text 001: Name of selected active preset.
E7-PRESET NOT CONFIGURED: The following field
shows the errors found while the system was running
or the commands received via serial (visualization can
be enabled or disabled only for received commands).
MNVCUCT_1511_EN

10.2 Saving a Preset

10.2.1 Quick save

Using the control keyboard it is possible to save the
current position. For further information, refer to the
manual of the keyboard in use.
During the saving stage, it is possible to change the
speed at which Preset is reached using keys Focus
Far/Focus Near and to change the waiting time using
keys Iris Open/Iris Close.
12345
Fig. 92

10.2.2 Saving from the Menu

Refer to 8.1.10.3 Preset Menu, page 36.
------------------------
SET PRESET
Focus to change speed
Iris to change dwell
Joystick to exit
------------------------
Speed : 100deg./s
Dwell : 5s
Pan : - 5.56
Tilt: +120.01
Zoom: 36.00x
49